Mejora de Liberación Rápida Max Trax

Yes, you can buy this product and install it on any rack you choose. You will need to get your own (M8) screws, as we cannot determine how thick your panel is.

This kit consists of 2 or 4, as you choose, quick-release pins with a plastic part that goes into the Max Trax support hole and the needed bolt.

You can also buy only two if you feel safer having the previous version to discourage theft, but still reducing the access time to your recovery boards by half.

THIS DOES NOT INCLUDE THE MAGNETS

Please, pay attention to this: the chrome cylinder on your actual supports, is tightened with Locktite, so it might be hard to unscrew, take a moment and do this properly with patience to not hurt yourself or damage the parts.

1. Remove the magnético supports from the Max Trax recovery boards.

2. Now that you have the magnets with the chrome cylinder and the black spacer, without the plastic top screw installed, put some same i.e. duct tape on the upper part of the cylinders.

3. With one hand, hold the magnet, with the other, with a clamp apply pressure on the duct tape and unscrew it.

4. DO NOT USE THE PLASTIC SPACER TO UNTIGHTEN THE CHROME CYLINDER; YOU WILL DAMAGE IT.

View this post on Instagram

A post shared by Sam (@big.adventure.van)