Close up of Tactic Engineering stainless steel quick release pin with safety cable installed on magnetic mount attached to white van surface, upgrade accessory for MaxTrax recovery board magnetic mounting system

Rogue Vans Mercedes Sprinter 4x4 Odyssey conversion with upgraded MaxTrax quick-release magnetic mounts by Tactic Engineering

MaxTrax snabbkopplingsuppgradering

CHF 126.00

Moms ingår för schweiziska kunder. Frakt från 10 €. Gratis över 150 € för beställningar på max 10 kg. Shipping calculated at checkout.

Number of pins

I lager, redo att skickas.Beställ före 11:00 CET: skickas inom 2 arbetsdagar. Annars 3.

★ 4.9 · 266 store reviewsShips from 🇨🇭 SwitzerlandSwiss VAT included2-year warranty

✓Complete your kit · save up to 15%

Trusted by the industry

Max Trax Quick Release Upgrade

Quick-release pins that replace the screw-in tops on your existing magnetic supports. Half the access time to your recovery boards.

Made in Switzerland2 or 4 pinsFits any rackMagnets not included

What you get

In the kit

2 or 4 quick-release pins

Each pin comes with the plastic part that goes into the Max Trax support hole, and the bolt it needs. Choose the count at checkout.

Option

Buy two, not four

Keep the previous version on the other two mounts if that feels safer against theft. Access time to your boards still drops by half.

Fit

Any rack you choose

You can install this on any rack. Source your own M8 screws — we cannot know how thick your panel is.

Read this

Magnets not included

This is an upgrade kit for supports you already own. It does not include the magnets.

Swapping it onto your existing supports

Before you start

The chrome cylinder on your current supports is tightened with Loctite, so it can be hard to unscrew. Take your time and do this properly, so you do not hurt yourself or damage the parts.

1. Remove the magnetic supports from the Max Trax recovery boards.
2. With the magnets, chrome cylinder and black spacer in hand — plastic top screw not installed — put some tape, duct tape works, on the upper part of the cylinders.
3. Hold the magnet with one hand. With the other, apply pressure on the taped section with a clamp and unscrew it.

Do not do this

Do not use the plastic spacer to untighten the chrome cylinder. You will damage it.

From the wild

View this post on Instagram
A post shared by Sam (@big.adventure.van)

Sam (@big.adventure.van) on Instagram

Max Trax® is a trademark of its owner. Tactic Engineering is an independent manufacturer and is not affiliated with, endorsed by, or sponsored by MaxTrax.

swiss